DAC 104 All Purpose Foam

Why was ALL PURPOSE FOAM developed?

All Pur­pose Foam was for­mu­lated to elim­i­nate costly prob­lems from rust for­ma­tion on the backs of molds, paint soft­en­ing on expen­sive equip­ment, and costly down time caused by gas build-up in vents.

Per­for­mance Characteristics:

• Removes rust from the backs of molds
• Removes gas build-up in vents from Del­rin and Nylon
• Cleans gran­ite blocks with­out leav­ing residue
• Superb machine degreaser
• Out­stand­ing per­for­mance on ver­ti­cal surfaces
• Excel­lent for gen­eral cleaning

Descrip­tion:

All Pur­pose Foam is a rich, high-density foam that will cling to ver­ti­cal sur­faces allow­ing enough time to close and mold over the top along with blow­ing out the vents. This is made espe­cially for del­rin gas build-up.

Rust Removal from the Backs of Molds:

Apply DAC-104 All Pur­pose Foam to sur­face. Rub gen­tly with a scour­ing pad until rust is removed. Flush sur­faces. Apply DAC-101 Mois­ture Guard on mold to pre­vent rust from reform­ing. Can may be sprayed in any desired posi­tion. Shake well before using.

Removal of Gas Build-Up of in Vents:

Use DAC-102 “On Line Resin Remover” as directed before use of this prod­uct to ini­ti­ate mol­e­c­u­lar break­down of gas film. Dry thor­oughly. Fill mold entirely with All Pur­pose Foam. Close mold and begin mold process if needed. Refill the cav­ity with All Pur­pose Foam if nec­es­sary. It is strongly rec­om­mended to rinse with sol­vent based DAC-103 “Uni­ver­sal All Pur­pose Degreaser” after the gas removal process to ensure rust for­ma­tion does not occur.

Gen­eral Cleaning:

Spray All Pur­pose Foam onto sur­faces requir­ing clean­ing. Allow foam to work for sev­eral sec­onds. Wipe away residue with a clean, dry cloth or sponge.

Cau­tion:

All Pur­pose Foam is water based. DO NOT use at exces­sive mold tem­per­a­tures (over 200′F).